The Dual Rectifier is waveform processor that specialises in converting bipolar signals into unipolar. The module is composed of two sections:
The top section is a Positive Rectifier with 1 input and 3 outputs:
- output 1 = Inverted copy of the input
- output 2 = Half-rectified – will clip the input signal below 0V.
- output 3 = Full-rectified will “fold” input signal below 0V.
The lower section is a Negative Rectifier with 1 input and 3 outputs:
- output 1 = Inverted copy of the input
- output 2 = Half-rectified – will clip the input signal above 0V.
- output 3 = Full-rectified – will “fold” input signal above 0V.
By default input 2 is normalled to output 1 (inverted) of the top section.
Voltage Processor – Build Guide | User Manual
All SMD parts come already pre-soldered
Specs:
- Width: 2HP
- Depth: 20mm (skiff friendly)
- Power: +12V : 15mA, -12V : 15mA
