Adapt a Teenage Engineering Pocket Operator for use as a 12HP Eurorack module. This DIY Kit comes with all SMD components already pre-soldered and contains all the other components needed to build the PO Adaptor (Pocket Operator not included).
This adaptor has the following functions:
• hold a Pocket Operator in your Eurorack Case
• supply power to the PO from Euro bus-power
• route the I/O 3.5mm jacks to the front
• divide incoming 16th-note clock to a 8th-note clock used by the PO
• safeguard against higher trigger voltages than the PO accepts
• amplify the output signal times 2
It is up to you to decide which of these functions you want to use. Read the manual carefully and completely before building
Build Document – User Manual & Assembly Guide
